Cranes & Derricks Compliance for Aerospace
29 CFR 1926 Subpart CC — Subpart CC governs the use of cranes, derricks, hoists, and similar equipment in construction. Covers operator certification, signal-person qualification, lift planning, ground conditions, power-line clearance, and inspection.
Any construction employer using power-operated equipment used in construction that can hoist, lower, and horizontally move a suspended load.
How Cranes & Derricks Applies to Aerospace
Aerospace facility construction and large-tool installation use cranes; integration with FOD prevention and security clearance for crane crews adds documentation steps.
Key Requirements
- Operator certification by an accredited testing organization (NCCCO or equivalent) — required for cranes >2,000 lb capacity
- Qualified signal person whenever signals are used
- Pre-lift inspection by a competent person; annual comprehensive inspection by a qualified person
- Ground conditions assessment and documentation before set-up
- Power-line clearance — 20 ft minimum for lines up to 350 kV (or use Table A); encroachment-prevention plan
- Critical-lift plans for engineered, multi-crane, or near-energized-line lifts
- Assembly/disassembly under direction of a qualified A/D director
- Operator and rigger training documentation maintained on site
Most-Cited Violations
1926.1427 — Operator not certified or qualified1926.1408 — Power-line clearance not maintained1926.1412 — Inspection deficiencies (no daily, no annual)1926.1404 — Improper assembly/disassembly procedures
Typical fine range: $10,000–$16,550 per Serious citation. Crane fatalities elevate to Willful ($50K–$165,514) and almost always trigger NEP follow-up across the contractor's other sites.
How SafetyNet Helps Aerospace Employers Comply with Cranes & Derricks
- Gap Assessment — Third-party audit against 1926.1400 with prioritized remediation roadmap.
- On-Site Managed Services — Embedded certified safety professional running your Cranes & Derricks program day-to-day.
- Citation Assistance — If you have received a 1926.1400 citation, our consultants help with informal-conference negotiation and abatement.
Free Tools
- Free OSHA Self-Assessment — 26-question check in 5 minutes
- OSHA Fine Estimator — Estimate your citation exposure
- Talk to a Consultant — Free 30-minute consultation
Cranes & Derricks for Other Industries
Other Standards Relevant to Aerospace
This page summarizes federal OSHA requirements. State-plan jurisdictions may have stricter requirements. Fine ranges are planning estimates; they are not legal advice. For a binding compliance assessment, contact a SafetyNet consultant.